Onto step 5 (only 45 more steps to go!) Assembling the body mount onto the shock tower.

OK, here is my 1st problem. This little set screw pin holds the body washer onto the body post. Or at-least it is meant to be. I could not get it to thread into the body mount so that the pin portion of the set screw held the opposite side of the washer in place.

Upon further examination the set screw pins were shorter then the ones in the 1:1 diagram. These were the only pins in the whole kit.

So instead I used a super high tech mechanism known as a body pin. An easy fix.

Shock tower with body mount and ball studs.

Step six parts. Pay attention here. Durango updated parts in this step.

Here you can see the updated addendum and parts. The updated parts and the updated portion of the instructions are all in one bag. In this step we will be using the updated front bulkhead.You can see it in the upper left by my thumb.

Everything screwed down.

Looking good.